Step
Enter Layer 2 Ethernet
2.
interface view or Layer 2
aggregate interface view.
Configure an MVRP
3.
registration mode.
Configuring MRP timers
To avoid frequent VLAN registrations and deregistrations, use the same MRP timers throughout the
network.
Each port maintains its own Periodic, Join, and LeaveAll timers, and each attribute of a port
maintains a Leave timer.
To configure MRP timers:
Step
Enter system view.
1.
Enter Layer 2 Ethernet
2.
interface view or Layer 2
aggregate interface view.
Configure the LeaveAll timer.
3.
Configure the Join timer.
4.
Configure the Leave timer.
5.
Configure the Periodic timer.
6.
Table 14
shows the value ranges for Join, Leave, and LeaveAll timers and their dependencies.
•
If you set a timer to a value beyond the allowed value range, your configuration fails. You can
set a timer by tuning the value of any other timer. The value of each timer must be an integer
multiple of 20 centiseconds and in the range defined in
•
As a best practice, restore the timers in the order of Join, Leave, and LeaveAll.
Command
interface interface-type
interface-number
mvrp registration { fixed |
forbidden | normal }
Command
system-view
interface interface-type
interface-number
mrp timer leaveall timer-value
mrp timer join timer-value
mrp timer leave timer-value
mrp timer periodic timer-value
177
Remarks
N/A
Optional.
The default setting is normal
registration mode.
Remarks
N/A
N/A
Optional.
The default setting is 1000
centiseconds.
Optional.
The default setting is 20
centiseconds.
Optional.
The default setting is 60
centiseconds.
Optional.
The default setting is 100
centiseconds.
You can restore the Periodic timer
to the default at any time.
Table
14.