Layer 3 Static Aggregation Configuration Example - H3C S7500E-X Configuration Manual

GE1/0/2
The output shows that GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 are in Individual state when
they have not received LACPDUs from the server. Both GigabitEthernet 1/0/1 and GigabitEthernet
1/0/2 can forward packets, which ensures zero packet loss.

Layer 3 static aggregation configuration example

Network requirements
On the network shown in
•
Configure a Layer 3 static aggregation group on both Device A and Device B.
•
Configure IP addresses and subnet masks for the corresponding Layer 3 aggregate interfaces.
Figure 13 Network diagram
GE1/0/1
GE1/0/2
GE1/0/3
Device A
Configuration procedure
Configure Device A:
1.
# Create Layer 3 aggregate interface Route-Aggregation 1, and configure an IP address and
subnet mask for the aggregate interface.
<DeviceA> system-view
[DeviceA] interface route-aggregation 1
[DeviceA-Route-Aggregation1] ip address 192.168.1.1 24
[DeviceA-Route-Aggregation1] quit
# Assign Layer 3 Ethernet interfaces GigabitEthernet 1/0/1 through GigabitEthernet 1/0/3 to
aggregation group 1.
[DeviceA] interface gigabitethernet 1/0/1
[DeviceA-GigabitEthernet1/0/1] port link-aggregation group 1
[DeviceA-GigabitEthernet1/0/1] quit
[DeviceA] interface gigabitethernet 1/0/2
[DeviceA-GigabitEthernet1/0/2] port link-aggregation group 1
[DeviceA-GigabitEthernet1/0/2] quit
[DeviceA] interface gigabitethernet 1/0/3
[DeviceA-GigabitEthernet1/0/3] port link-aggregation group 1
[DeviceA-GigabitEthernet1/0/3] quit
Configure Device B in the same way Device A is configured. (Details not shown.)
2.
Verifying the configuration
# Display detailed information about all aggregation groups on Device A.
[DeviceA] display link-aggregation verbose
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Port Status: S -- Selected, U -- Unselected, I -- Individual
Flags: A -- LACP_Activity, B -- LACP_Timeout, C -- Aggregation,
D -- Synchronization, E -- Collecting, F -- Distributing,
G -- Defaulted, H -- Expired
Aggregate Interface: Route-Aggregation1
0 32768
Figure 13, perform the following tasks:
Link aggregation 1
RAGG1
192.168.1.1/24 192.168.1.2/24
0 0x8000, 0000-0000-0000 {DEF}
GE1/0/1
GE1/0/2
GE1/0/3
RAGG1
Device B
48