Setting Other Lldp Parameters - H3C S7500E-X Configuration Manual

Step
Allow LLDP to advertise the
3.
management address in
LLDP frames and configure
the advertised management
address.
Set the encoding format of
4.
the management address to
string.

Setting other LLDP parameters

The Time to Live TLV carried in an LLDPDU determines how long the device information carried in
the LLDPDU can be saved on a recipient device.
By setting the TTL multiplier, you can configure the TTL of locally sent LLDPDUs. The TTL is
expressed by using the following formula:
TTL = Min (65535, (TTL multiplier × LLDP frame transmission interval + 1))
As the expression shows, the TTL can be up to 65535 seconds. TTLs greater than 65535 will be
rounded down to 65535 seconds.
To set LLDP parameters:
Step
Enter system view.
1.
Set the TTL multiplier.
2.
Set the LLDP frame
3.
transmission interval.
Set the token bucket size for
4.
sending LLDP frames.
Command
•
In Layer 2/Layer 3 Ethernet
interface view or
management Ethernet
interface view:
lldp [ agent
{ nearest-customer |
nearest-nontpmr } ]
tlv-enable basic-tlv
management-address-tlv
[ ip-address ]
•
In Layer 2/Layer 3
aggregate interface view:
lldp agent
{ nearest-customer |
nearest-nontpmr }
tlv-enable basic-tlv
management-address-tlv
[ ip-address ]
•
In Layer 2/Layer 3 Ethernet
interface view or
management Ethernet
interface view:
lldp [ agent
{ nearest-customer |
nearest-nontpmr } ]
management-address-for
mat string
•
In Layer 2/Layer 3
aggregate interface view:
lldp agent
{ nearest-customer |
nearest-nontpmr }
management-address-for
mat string
Command
system-view
lldp hold-multiplier value
lldp timer tx-interval interval
lldp max-credit credit-value
229
Remarks
By default:
•
Nearest bridge agents and
nearest customer bridge
agents can advertise the
management address in
LLDP frames.
•
Nearest non-TPMR bridge
agents cannot advertise the
management address in
LLDP frames.
By default, the encoding format of
the management address is
numeric.
Remarks
N/A
The default setting is 4.
The default setting is 30
seconds.
The default setting is 5.