Step
Enter aggregate interface
2.
view.
Set the minimum number of
3.
Selected ports for the
aggregation group.
Set the maximum number of
4.
Selected ports for the
aggregation group.
Setting the expected bandwidth for an aggregate interface
Step
Enter system view.
1.
Enter aggregate interface
2.
view.
Set the expected bandwidth
3.
for the interface.
Configuring an edge aggregate interface
When you configure an edge aggregate interface, follow these restrictions and guidelines:
•
This configuration takes effect only on the aggregate interface corresponding to a dynamic
aggregation group.
•
Link-aggregation traffic redirection does not operate correctly on an edge aggregate interface.
For more information about link-aggregation traffic redirection, see
traffic
redirection."
To configure an edge aggregate interface:
Step
Enter system view.
1.
Command
•
Enter Layer 2 aggregate
interface view:
interface
bridge-aggregation
interface-number
•
Enter Layer 3 aggregate
interface view:
interface
route-aggregation
interface-number
link-aggregation selected-port
minimum number
link-aggregation selected-port
maximum number
Command
system-view
•
Enter Layer 2 aggregate
interface view:
interface
bridge-aggregation
interface-number
•
Enter Layer 3 aggregate
interface view:
interface
route-aggregation
interface-number
bandwidth bandwidth-value
Command
system-view
35
Remarks
N/A
By default, the minimum number
of Selected ports for the
aggregation group is not
specified.
By default, the maximum number
of Selected ports for an
aggregation group depends on
hardware limitation.
Remarks
N/A
N/A
By default, the expected
bandwidth (in kbps) is the
interface baud rate divided by
1000.
"Enabling link-aggregation
Remarks
N/A