Step
Enter aggregate interface
2.
view.
Configure the aggregate
3.
interface as an edge
aggregate interface.
Shutting down an aggregate interface
Shutting down or bringing up an aggregate interface affects the aggregation states and link states of
member ports in the corresponding aggregation group as follows:
•
When an aggregate interface is shut down, all Selected ports in the corresponding aggregation
group become Unselected ports and all member ports go down.
•
When an aggregate interface is brought up, the aggregation states of member ports in the
corresponding aggregation group are recalculated.
The loopback command cannot be configured on the member port of a shutdown aggregate
interface. A port configured with the loopback command cannot be assigned to a shutdown
aggregate interface. For more information about the loopback command, see Interface Command
Reference.
To shut down an aggregate interface:
Step
Enter system view.
1.
Enter aggregate interface
2.
view.
Shut down the aggregate
3.
interface.
Restoring the default settings for an aggregate interface
You can restore all configurations on an aggregate interface to the default settings.
To restore the default settings for an aggregate interface:
Command
•
Enter Layer 2 aggregate
interface view:
interface
bridge-aggregation
interface-number
•
Enter Layer 3 aggregate
interface view:
interface
route-aggregation
interface-number
lacp edge-port
Command
system-view
•
Enter Layer 2 aggregate
interface view:
interface
bridge-aggregation
interface-number
•
Enter Layer 3 aggregate
interface view:
interface
route-aggregation
interface-number
shutdown
36
Remarks
N/A
By default, an aggregate interface
does not operate as an edge
aggregate interface.
Remarks
N/A
N/A
By default, an aggregate interface
is up.