Specifying Ignored Vlans For A Layer 2 Aggregate Interface; Reserving A Vlan Interface Resource For A Layer 2 Aggregate Interface - H3C S7500E-X Configuration Manual

Step
Set the description for
3.
the aggregate interface.

Specifying ignored VLANs for a Layer 2 aggregate interface

By default, to become Selected ports, the member ports must have the same VLAN permit state and
VLAN tagging mode as the corresponding Layer 2 aggregate interface.
The system ignores the permit state and tagging mode of an ignored VLAN when choosing Selected
ports.
To specify ignored VLANs for a Layer 2 aggregate interface:
Step
Enter system view.
1.
Enter Layer 2 aggregate
2.
interface view.
Specify ignored VLANs.
3.
Reserving a VLAN interface resource for a Layer 2 aggregate
interface
Perform this task to reserve a VLAN interface resource for a Layer 2 aggregate interface whose
corresponding aggregation group uses RPR logical interfaces as member ports. The reserved VLAN
interface resource is used for traffic forwarding on the RPR logical interfaces.
You must reserve a VLAN interface resource for a Layer 2 aggregate interface after assigning RPR
logical interfaces to the corresponding Layer 2 aggregation group. After the resource of a VLAN
interface is reserved, you cannot use the vlan and undo vlan commands to create and delete the
VLAN.
To reserve a VLAN interface resource for a Layer 2 aggregate interface:
Step
Enter system view.
1.
Enter Layer 2 aggregate
2.
interface view.
Reserve a VLAN interface
3.
resource for the Layer 2
aggregate interface.
Command
description text
Command
system-view
interface bridge-aggregation
interface-number
link-aggregation ignore vlan
vlan-id-list
Command
system-view
interface bridge-aggregation
interface-number
rpr reserve-vlan vlan vlan-id
33
Remarks
By default, the description of an
interface is interface-name
Interface.
Remarks
N/A
N/A
By default, a Layer 2 aggregate
interface does not ignore any
VLANs.
Remarks
N/A
N/A
By default, no VLAN interface
resource is reserved for a Layer 2
aggregate interface.
You must specify a nonexistent
VLAN for the vlan vlan-id option.
Otherwise, the configuration fails.