Configuration Prerequisites; Enabling Mvrp; Configuring An Mvrp Registration Mode - H3C S7500E-X Configuration Manual

receive undesired copies. For more information about port mirroring, see Network Management
and Monitoring Configuration Guide.
•
MVRP takes effect only on trunk ports. For more information about trunk ports, see
VLANs."
•
Enabling MVRP on a Layer 2 aggregate interface takes effect on the aggregate interface and all
Selected member ports in the link aggregation group.
•
MVRP configuration made on an aggregation group member port takes effect only after the port
is removed from the aggregation group.

Configuration prerequisites

Before configuring MVRP, make sure each MSTI is mapped to an existing VLAN on each device in
the network.

Enabling MVRP

Step
Enter system view.
1.
Enable MVRP globally.
2.
Enter Layer 2 Ethernet
3.
interface view or Layer 2
aggregate interface view.
Configure the port as a trunk
4.
port.
Configure the trunk port to
5.
permit the specified VLANs.
Enable MVRP on the port.
6.

Configuring an MVRP registration mode

Step
Enter system view.
1.
Command
system-view
mvrp global enable
interface interface-type
interface-number
port link-type trunk
port trunk permit vlan
{ vlan-id-list | all }
mvrp enable
Command
system-view
176
"Configuring
Remarks
N/A
By default, MVRP is globally
disabled.
For MVRP to take effect on a port,
enable MVRP both on the port
and globally.
N/A
By default, each port is an access
port. For more information about
the port link-type trunk
command, see Layer 2 —
Switching Command Reference.
By default, a trunk port permits
only VLAN 1.
Make sure the trunk port permits
all registered VLANs.
For more information about the
port trunk permit vlan
command, see Layer 2 —
Switching Command Reference.
By default, MVRP is disabled on a
port.
Remarks
N/A
LAN
LAN