Layer 2 Edge Aggregate Interface Configuration Example - H3C S7500E-X Configuration Manual

Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Port Status: S -- Selected, U -- Unselected, I -- Individual
Flags: A -- LACP_Activity, B -- LACP_Timeout, C -- Aggregation,
D -- Synchronization, E -- Collecting, F -- Distributing,
G -- Defaulted, H -- Expired
Aggregate Interface: Bridge-Aggregation1
Aggregation Mode: Static
Loadsharing Type: Shar
Port
--------------------------------------------------------------------------------
GE1/0/1
GE1/0/2
Aggregate Interface: Bridge-Aggregation2
Aggregation Mode: Static
Loadsharing Type: Shar
Port
--------------------------------------------------------------------------------
GE1/0/3
GE1/0/4
The output shows that:
•
Link aggregation groups 1 and 2 are both load-shared Layer 2 static aggregation groups.
•
Each aggregation group contains two Selected ports.
# Display all the group-specific load sharing modes on Device A.
[DeviceA] display link-aggregation load-sharing mode interface
Bridge-Aggregation1 Load-Sharing Mode:
source-mac address
Bridge-Aggregation2 Load-Sharing Mode:
destination-mac address
The output shows that:
•
Link aggregation group 1 load shares packets based on source MAC addresses.
•
Link aggregation group 2 load shares packets based on destination MAC addresses.

Layer 2 edge aggregate interface configuration example

Network requirements
As shown in
Configure an edge aggregate interface so that GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2 can
forward packets from the server during the server reboot process.
Status Priority Oper-Key
S 32768
S 32768
Status Priority Oper-Key
S 32768
S 32768
Figure 12, the device and the server are two ends of a Layer 2 dynamic aggregate link.
1
1
2
2
46