Layer 3 Aggregation Load Sharing Configuration Example - H3C S7500E-X Configuration Manual

[DeviceA] display link-aggregation verbose
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Port Status: S -- Selected, U -- Unselected, I -- Individual
Flags: A -- LACP_Activity, B -- LACP_Timeout, C -- Aggregation,
D -- Synchronization, E -- Collecting, F -- Distributing,
G -- Defaulted, H -- Expired
Aggregate Interface: Route-Aggregation1
Aggregation Mode: Dynamic
Loadsharing Type: Shar
System ID: 0x8000, 000f-e267-6c6a
Local:
Port
--------------------------------------------------------------------------------
GE1/0/1
GE1/0/2
GE1/0/3
Remote:
Actor
--------------------------------------------------------------------------------
GE1/0/1
GE1/0/2
GE1/0/3
The output shows that link aggregation group 1 is a Layer 3 dynamic aggregation group that contains
three Selected ports.

Layer 3 aggregation load sharing configuration example

Network requirements
On the network shown in
•
Configure Layer 3 static aggregation groups 1 and 2 on Device A and Device B, respectively.
•
Configure IP addresses and subnet masks for the corresponding Layer 3 aggregate interfaces.
•
Configure link aggregation group 1 to load share packets based on source IP addresses.
•
Configure link aggregation group 2 to load share packets based on destination IP addresses.
Figure 15 Network diagram
Configuration procedure
Configure Device A:
1.
# Create Layer 3 aggregate interface Route-Aggregation 1.
<DeviceA> system-view
[DeviceA] interface route-aggregation 1
Status Priority Oper-Key
S 32768 1
S 32768 1
S 32768 1
Partner Priority Oper-Key
1 32768 1
2 32768 1
3 32768 1
Figure 15, perform the following tasks:
Flag
{ACDEF}
{ACDEF}
{ACDEF}
SystemID
0x8000, 000f-e267-57ad {ACDEF}
0x8000, 000f-e267-57ad {ACDEF}
0x8000, 000f-e267-57ad {ACDEF}
50
Flag