Using The Controller Link Support Software And Cx-Programmer; Using Fins Commands - Omron C200HW-CLK21 Operation Manual

Starting and Stopping Data Links
CVM1 and CV-series Start Bit
15 14 13 12 11 10 9
Word N
N: DM 2000 + 100
CQM1H-series Start Bit
15 14 13 12 11 10 9
AR 07
5-3-2

Using the Controller Link Support Software and CX-Programmer

Using a Programming Device Connected to PLC Node
Using a Computer Node
5-3-3

Using FINS Commands

Issuing the FINS Command from a Computer Node
8 7 6 5 4 3
(unit number)
8 7 6 5 4 3
Data links can be started or stopped using commands on the Data Link Menu
of the Controller Link Support Software. The node for which starting and stop-
ping is being specified must participate in the data links.
IBM PC/AT or Controller Link Support Software or
CX-Net (in CX-Programmer)
compatible
Note The Controller Link Support Software cannot be connected to a CS-series PLC.
Use the CX-Net (in CX-Programmer).
IBM PC/AT or
compatible
Controller Link
Support Board
Data links can be started or stopped from the Controller Link Support Board
on the local node.
Data links can be started and stopped by sending the RUN and STOP FINS
commands from a node on the Controller Link to a node that is in the data
links.
IBM PC/AT or
compatible
Controller Link
Support Board
2 1 0
Data link Start Bit
Start: Changed from OFF to ON or set to ON
when power is turned on
Stop: Changed from ON to OFF
2 1 0
Data link Start Bit
Start: Changed from OFF to ON or set to ON
when power is turned on
Stop: Changed from ON to OFF
Start/stop data links
Controller Link
Support Software
Start/stop data links
FINS command:
RUN/STOP
Section 5-3
Node in data links
Node in data links
Node in data links
155