Omron C200HW-CLK21 Operation Manual page 86

Unit Installation
CJ-series PLCs
CPU Rack
P
S
CJ-series Expansion
Rack
P
S
CJ-series Expansion
Rack
P
S
CJ-series Expansion
Rack
P
S
Up to a total of four Controller Link Units for CJ-series PLCs can be connected
in a CPU Rack or a Expansion Rack. (Be sure to secure the Units with the top
and bottom sliders.)
C I
P C
U
10 Unit max.
I
I
10 Unit max.
I
I
10 Unit max.
I
I
10 Unit max.
PS: Power Supply Unit
CPU: CPU Unit
IC: I/O Control Unit
II: I/O Interface Unit
Note When installing several CJ-series CPU Bus Units at the same time, a total of
16 CJ-series CPU Bus Units maximum may be installed.
Up to eight CS/CJ-series Controller Link Units with unit version 1.2 or later
can be connected to a single CPU Unit. When connecting multiple Controller
Link Units to the CPU Unit, consider the current consumption of the CPU Unit
and each CPU Bus Unit before selecting the Power Supply Unit. For details on
Controller Link Unit current consumption, refer to Controller Link Unit Models
and PLCs on page 16 . For details on current consumption of each Unit, refer
to the SYSMAC CJ Series Programmable Controllers Operation Manual
(W393).
The following table provides an example of current consumption
End Cover
End Cover
Of these slots, installation
is possible in up to 8 slots
(unit Ver. 1.2 or later).
Installation in up to 4 slots
is possible for pre-Ver. 1.2
Units.
End Cover
End Cover
Section 3-2
63