Controller Setup - Omron NX Series Network Connection Manual

6.3. Controller Setup

Set up the controller.
6.3.1. Setting the Hardware
Check the connection of the Serial Communications Unit.
Precautions for Correct Use
Turn OFF the power supply before setting the hardware.
1
Confirm that the power supply
to the controller is OFF.
* If the power supply is ON, you
may not be able to proceed
with the subsequent steps of
the procedure.
Check the position of the "Port
2" (RS-232C) connector as
shown in the figure on the right.
* It is assumed that "Port 2" of
the Serial Communications
Unit is used.
2
Connect the Serial
Communications Unit to the
controller, as shown in the figure
on the right.
Connect the dedicated cable of
the code reader cable to the
Serial Communications Unit.
Connect the controller to the PC
with a LAN cable.
PC
NX1P2-
LAN cable
9024
6. Connection Procedure
Port 2 (RS-232C)
Serial Communications Unit
End Cover
Code reader
Dedicated cable
19