Wire-To-Optical (H-Pcf) Repeater Unit - Omron C200HW-CLK21 Operation Manual

Component Names and Functions
3-1-7

Wire-to-Optical (H-PCF) Repeater Unit

SL1 Terminal Block for Communications
Cable
Terminals to connect to the Controller
Link Network communications cable
(twisted-pair cable).
Baud rate switch
Power Terminal Block
Terminals to connect to the
power supply (24 V DC) that
drives the Repeater Unit.
Repeater Unit Indicators
56
CS1W-RPT02
PWR
T/R1
T/R2
BD H
BD L
SHLD
TER SW
ON
SW1
1 BAUD
2 RATE
+
DC24V
INPUT
Name Color
PWR Green
(Power supply)
T/R1 Yellow
(SL1 communicat-
ing)
TR2 Yellow
(SL2 2 communicat-
ing)
Indicators
LED indicators that display the status of the
Unit and communications.
Terminating Resistance Switch for SL1
Turn ON this switch when the Repeater Unit is
SL1
connected to the SL1 communications cable
terminal block at either end of the Controller Link
Network.
ON
SL2
Optical Connector SL2
Connects to communications cable
(H-PCF optical fiber cable) of the
Controller Link Network.
Status
Lit Power supply is ON.
Not lit Power supply is OFF.
Lit Transmission signal is being sent or
received.
Not lit No transmission signal.
Lit Transmission signal is being sent or
received.
Not lit No transmission signal.
Section 3-1
Meaning