Omron C200HW-CLK21 Operation Manual page 61

Data Links Procedures
38
1 to 1 Type
Contents
a. Set the data link mode
to automatic.
b. 1:N creation
c. Set the area
d. Set the data link start
word
e. Set the number of
common send words
per master node
f. Se the number of indi-
vidual send words per
master node
g. Set the number of
send words per slave
node
h. Set the first data link
status word
i. Set the nodes to par-
ticipate in the data
links.
Note For automatic data link creation with 1:N allocation, use CX-Net in
CX-Programmer version 3.2 or higher.
Method
Use Support Soft- Data link startup node
ware for the PLC only
including Program-
The node that is used
ming Console (see
to start the data link is
note).
called the startup
node. It is necessary
to decide beforehand
which node will be
the startup node.
Data link startup node
only
Section 2-1
Nodes Page
113
138