Remote Controller Link Networks - Omron C200HW-CLK21 Operation Manual

Remote Programming and Monitoring
CX-Programmer
CX-Programmer
7-2-2

Remote Controller Link Networks

SYSMAC Support Software or CV Support Software
SYSMAC Support
Software (CVM1 Only)
or
CV Support Software
Note Remote programming and monitoring is not possible from computer nodes. Computer
nodes can only monitor Controller Link Network status. A Programming Device connected
to a C200HX/HG/HE PLC cannot remotely program or monitor a node on a remote network.
A CX-Programmer connected to a CS/CJ-series, C200HX/HG/HE, CVM1,
CV-series, or CQM1H CPU Unit can program and monitor a CPU Unit on the
same network. Programming and monitoring are possible, including CPU
Units that are different to the one to which the Programming Device is con-
nected.
Programming Device
CS/CJ-series,
C200HX/HG/HE,
CVM1, CV-series,
or CQM1H PLC
Note Remote programming and monitoring are possible from a factory automation
node computer using the CX-Programmer.
A Programming Device connected to a CVM1 or CV-series CPU Unit can pro-
gram and monitor a CVM1 or CV-series PLC on another Controller Link Net-
work through a CVM1 or CV-series PLC. Other types of PLC cannot be
programmed or monitored on remote networks.
Programming Device
Controller Link Network
CVM1 or
CV-series PLC
Controller Link
Support Software
Controller Link Network
CS/CJ-series,
C200HX/HG/HE,
CVM1, CV-series,
or CQM1H PLC
Controller Link Network
CS/CJ-series, CVM1,
or CV-series PLC
Controller Link Network Controller Link Network
CS/CJ-series, CVM1,
or CV-series PLC
Section 7-2
Programming
and monitoring
Programming
and monitoring
CS/CJ-series PLC
Controller Link Network
Programming
and monitoring
CVM1 or
CV-series PLC
237