Enabling And Disabling Diagnostic Software - Nortel Passport 2430 Installing And Operating Instructions

Table 4-2.
Diagnostic Test
Testing SDB Module
in Slot 1
Testing SDB Module
in Slot 2
If you need assistance, contact your local Nortel Networks Technical Solutions
Center.

Enabling and Disabling Diagnostic Software

If you do not want diagnostic testing when the Passport 2430 starts, disable the
diagnostic software by entering:
diags-off
The diagnostic testing will not run when you start the Passport 2430.
Note: Although disabling the diagnostic software decreases the start-up time,
Nortel Networks recommends that the diagnostic software runs by default
when you start the Passport 2430.
308224-B Rev 00
Diagnostic Testing
Possible Results (continued)
PASSED - The WAN adapter module is operational.
The software proceeds to test the next module.
FAILED - The WAN adapter module is not
operational. The software proceeds to test the next
module.
NOT PRESENT - There is no WAN adapter module
in Slot 1. The software proceeds to test the next
module.
PASSED - The WAN adapter module is operational.
The software starts the bootstrap.
FAILED - The WAN adapter module is not
operational. This is considered a bootable error; the
software starts the bootstrap.
NOT PRESENT - The software does not detect a
WAN adapter module in Slot 2. The software starts
the bootstrap.
Operating the Passport 2430
4-7