Generator; Generator Belt - Suzuki 2000 Grand Vitara SQ625 Service Manual

1. Generator belt

2. Crankshaft pulley
3. Radiator fan pulley
4. Tension pulley
5. Tensioner

GENERATOR

GENERATOR BELT
[G16 and H25 engines]
Refer to "COOLING FAN BELT" in SECTION 6B "ENGINE COOL-
ING".
[J20 engine]
INSPECTION
_ Inspect belt for cracks, cuts, deformation, wear and cleanliness.
If any of above conditions are found replace generator belt.
_ Check to make sure that tension indicators are as follows in the
left figure by using mirror.
(a) If the tension indicator "B" is found to the left of the indicator
"A", replace the generator belt.
(b) If new generator belt has been installed, indicator "A" should
be within "a" of the left figure.
If it isn't, it means that belt is not installed properly.
Reinstall it properly.
REMOVAL
WARNING:
Disconnect negative cable at battery before removing and
installing generator belt.
1) Loosen tensioner by turning the tensioner pulley clock wise.
2) While holding the tensioner and belt loose, remove generator
belt.
INSTALLATION
1) Loosen tensioner by turning the tensioner pulley clockwise.
2) While holding the tensioner, install generator belt.
NOTE:
_ Make sure that the belt fits each pulley's groove properly.
_ After installing generator belt, perform checks described
above and make sure that tension indicator is within stan-
dard range.
1. Generator belt
2. Tensioner
3. Tensioner bolt
CHARGING SYSTEM 6H-13