Suzuki 2000 Grand Vitara SQ625 Service Manual page 261

1. Timing belt
2. Tensioner plate
3. Tensioner bolt
1. Camshaft allowable turning range - - - By timing
mark, within 90_ from "V" mark on head cover on
both right and left.
2. Crankshaft allowable turning range - - - By punch
mark, within 90_ from arrow mark on oil pump case
on both right and left.
7) For installation of timing belt, align 4 timing marks as shown in
1. "V" mark on
cylinder head
cover
2. Timing mark by "E"
on camshaft timing
belt pulley
3. Arrow mark on oil
pump case
4. Punch mark on
crankshaft timing
belt pulley
8) Remove timing belt tensioner, tensioner plate, tensioner spring
4. Tensioner
stud
5. Spring
INSPECTION
_ Inspect timing belt for wear or crack.
Replace it as necessary.
figure by turning crankshaft.
and timing belt.
CAUTION:
_ After timing belt is removed, never turn camshaft and
crankshaft independently more than such an extent as
shown in figure. If turned, interference may occur
among piston and valves, and parts related to piston
and valves may be damaged.
_ Never bend timing belt.
ENGINE MECHANICAL (G16 ENGINE) 6A1-19