Suzuki 2000 Grand Vitara SQ625 Service Manual page 721

6H-28 CHARGING SYSTEM
1. End housing bearing
2. Rotor
1, (a)
1. Stud bolt 3. Drive end bearing
2. Retaining plate 4. Stator
1. Rotor 2. Drive end frame
1. Rear end frame 2. Drive end frame
REASSEMBLY [70 A and 85 A types]
1) If end housing bearing is removed, install it.
2) Check end housing bearing turns smoothly.
3. Bearing cover
3) If stator is removed, install stator and tighten stud bolts.
4) If drive end bearing is removed, install it.
5) Check drive end bearing turns smoothly.
6) Place drive end frame on pulley, and then install rotor to drive
7) Install rear end frame to drive end frame.
8) Tighten 4 nuts to specified torque.
9) Install pulley and tighten pulley nut with holding shaft by using
1. Pulley
2. Hexagonal box
wrench
3. Offset wrench
Tightening Torque
.
(a): 8.8 N m (0.88 kg-m, 6.5 lb-ft)
.
(b): 2.6 N m (0.26 kg-m, 2.0 lb-ft)
end frame.
Tightening Torque
.
(a): 4.5 N m (0.45 kg-m, 3.5 lb-ft)
hexagonal box wrench to specified torque.
Tightening Torque
.
(a): 111 N m (11.1 kg-m, 80.5 lb-ft)