Suzuki 2000 Grand Vitara SQ625 Service Manual page 440

1. Retainer 4. Oil pump case No.2
2. Relief spring 5. Oil pump case pin
3. Relief valve
1. Lower crankcase
2. Oil pump
1. Oil pump sprocket cover
4) Install relief valve, relief spring and retainer to oil pump case
No.2.
Tighten retainer to specified torque.
Tightening Torque
.
(a): 29 N m (2.9 kg-m, 21.0 lb-ft)
5) Install oil pump case pins to oil pump case No.2.
6) Assemble oil pump. After assembling oil pump check to be sure
that rotor turns smoothly by hand.
Tightening Torque
.
(a): 12 N m (1.2 kg-m, 9.0 lb-ft)
INSTALLATION
1) Install oil pump to lower crankcase and tighten bolts to specified
torque.
NOTE:
When installing oil pump, be careful not to allow pins to fall
off.
Tightening Torque
.
(a): 27 N m (2.7 kg-m, 19.5 lb-ft)
2) Install oil pump sprocket cover and tighten bolts to specified
torque.
Tightening Torque
.
(a): 11 N m (1.1 kg-m, 8.0 lb-ft)
3) Install oil pan and oil pump strainer. Refer to "OIL PAN AND OIL
PUMP STRAINER" in this section.
4) Refill engine with engine oil, referring to item "ENGINE OIL
CHANGE" in Section 0B.
5) Connect negative cable at battery.
6) After completing installation, check oil pressure by running en-
gine. Refer to "OIL PRESSURE CHECK" in this section.
ENGINE MECHANICAL (J20 ENGINE) 6A4-21