6H-18 CHARGING SYSTEM
1. Screw
2. Generator "B" terminal nut
1. Brush holder
2. Solder
3. Brush spring
7) When removing rear bearing, use oil hydraulic press.
1. Rear bearing
2. Oil hydraulic
press
3. General rod
4. General tool
8) Remove three screws and generator "B" terminal nut.
3. "B" terminal
9) Unsolder stator leads and remove stator from rear housing and
1. Stator lead
(solder)
10) To remove brush, remove holder cover from brush holder and
regulator assembly.
then disconnect brush wire from regulator terminal by using
soldering iron.