Suzuki 2000 Grand Vitara SQ625 Service Manual page 443

6A4-24 ENGINE MECHANICAL (J20 ENGINE)
1. Crankshaft pulley
2. Bolt
3. Wrench
INSTALLATION
Reverse removal sequence to install timing chain cover noting fol-
lowing points.
1) Apply sealant "A" and "B" to area as shown in figure.
1. Timing chain cover
2. Cylinder head
3. Cylinder block
4. Dowel pin position
2) Apply engine oil to oil seal lip, then install timing chain cover.
1. Timing chain cover
2. Nut
3. Bolt
3) Install crankshaft pulley.
"A": Sealant 99000-31150
"B": Sealant 99000-31140
Tighten bolts and nut to specified torque.
NOTE:
Before installing timing chain cover, check that pin is se-
curely fitted.
Tightening Torque
.
(a): 11.0 N m (1.1 kg-m, 8.0 lb-ft)
To lock crankshaft pulley, use special tool (camshaft pulley hold-
er) with it at shown in figure.
Special Tool
(A): 09917-68221
NOTE:
Be sure to use the following bolt for fixing special tool to
crankshaft pulley.
Bolt size: M8, P1.25, L = 45 mm
Strength: 7T
Tightening Torque
.
(a): 150 N m (15 kg-m 108.5 lb-ft)