Suzuki 2000 Grand Vitara SQ625 Service Manual page 281

1. Camshaft timing belt pulley
8) Install camshaft oil seal.
1. Camshaft oil seal
9) Install rocker arm shaft plug and timing belt inside cover.
10) Install camshaft timing belt pulley to camshaft while fitting pin
2. Dwell pin
11) Using special tool, tighten pulley bolt to specified torque.
12) Install belt tensioner, timing belt, outside cover, crankshaft
13) After applying sealant to part "A" as shown in figure at the left,
1. O-ring
After applying engine oil to oil seal lip, press-fit camshaft oil
seal till oil seal surface becomes flush with housing surface.
Then tighten rocker arm shaft plug to specified torque.
Tightening Torque
.
(a): 33 N m (3.3 kg-m, 24.0 lb-ft)
on camshaft into slot at "E" mark.
Tightening Torque
.
(a): 60 N m (6.0 kg-m, 43.5 lb-ft)
Special Tool
(A): 09917-68220
pulley and water pump belt as previously outlined.
install CMP sensor case to cylinder head and tighten its fixing
bolts to specified torque.
"A" Sealant: 99000-31110
Tightening Torque
.
(a): 11 N m (1.1 kg-m, 8.0 lb-ft)
Connect CMP sensor connector.
ENGINE MECHANICAL (G16 ENGINE) 6A1-39