Suzuki 2000 Grand Vitara SQ625 Service Manual page 537

6C-8 ENGINE FUEL
Fastening portion Fastening portion
Fuel pump assembly bolt
Fuel tank bolt
Fuel tank protector bolt
Breather hose clamp
Fuel filler hose clamp
TIGHTENING TORQUE SPECIFICATION
9) Connect coupler to fuel pump assembly and tank pressure
sensor respectively.
10) Connect negative (–) cable to battery.
11) Upon completion of installation, check fuel system for leakage.
FUEL TANK PURGING PROCEDURE
CAUTION:
This purging procedure will NOT remove all fuel vapor. Do
not attempt any repair on tank where heat or flame is re-
quired, as an explosion resulting in personal injury could
occur.
The following procedure is used for purging the fuel tank.
1) After removing fuel tank, remove all hoses and fuel pump as-
sembly from fuel tank.
2) Drain all remaining fuel from tank.
3) Move tank to flushing area.
4) Fill tank with warm water or tap water, and agitate vigorously and
drain. Repeat this washing until inside of tank is clean.
Replace tank if its inside is rusty.
5) Completely flush out remaining water after washing.
.
N m
5.0
50 50
2.0
4.0
Tightening torque
kg-m
0.5
5.0 5 0
0.2
0.4
lb-ft
3.5
36.5 36 5
2.0
3.0