1. Bolts
2. Reduction gear assembly
1. Planetary gear
2. Packing
1. Seal rubber
2. Plate
1. Snap ring
2. Pinion stop ring
3. Over-running clutch
assembly
2) Remove bolts shown in left figure, then separate reduction gear
assembly from starting motor assembly.
3) To overhaul reduction gear assembly, remove packing and plan-
etary gears.
4) Remove seal rubber and plate.
5) Remove shaft assembly with lever.
1. Shaft ass'y
2. Lever
6) Loosen pinion stop ring fixed by snap ring.
CRANKING SYSTEM 6G-7