Suzuki 2000 Grand Vitara SQ625 Service Manual page 437

6A4-18 ENGINE MECHANICAL (J20 ENGINE)
3) Install O-rings in the position as shown in figure and install oil
4) After fitting oil pan to cylinder block, run in securing bolts and
5) Lower engine and tighten engine mounting nuts to specified
1. Oil pump
2. O-ring
3. Oil pump strainer
4. Oil pan
6) Install gasket and drain plug to oil pan.
7) Install clutch (torque converter) housing lower plate.
8) Connect exhaust pipe to exhaust manifold referring to Section
9) Install transmission stiffener to transmission and cylinder block
1. Oil pan
2. Drain plug
10) Install front differential housing according to installation proce-
11) Refill front differential housing with gear oil, referring to Section
12) Install steering gear box to vehicle referring to "Steering Gear
13) Install oil level gauge.
14) Refill engine with engine oil, referring to item "ENGINE OIL
15) Refill power steering system with specified fluid referring to
16) Verify that there is no engine oil leakage, differential oil leakage
pump strainer to oil pump.
Tighten strainer bolts first and then bracket bolt to specified
torque.
Tightening Torque
.
(a): 11 N m (1.1 kg-m, 8.0 lb-ft)
.
(b): 11 N m (1.1 kg-m, 8.0 lb-ft)
start tightening at the center: move wrench outward, tightening
one bolt at a time.
Tighten bolts and nuts to specified torque.
Tightening Torque
.
(c): 11 N m (1.1 kg-m, 8.0 lb-ft)
torque referring to "Engine Assembly Installation" in this sec-
tion.
Tighten drain plug to specified torque.
Tightening Torque
.
(a): 35 N m (3.5 kg-m, 25.5 lb-ft)
6K.
if equipped.
dure described in Section 7E.
7E.
Box Installation" in Section 3B1.
CHANGE" in Section 0B.
Section 3B1.
and power steering fluid leakage at each connection.