Suzuki 2000 Grand Vitara SQ625 Service Manual page 383

RH bank
LH bank
REMOVAL
1) Relieve fuel pressure according to procedure described in Sec-
2) Disconnect negative cable at battery.
3) Drain engine oil.
4) Drain coolant.
5) Remove CMP sensor, camshaft and valve lash adjuster.
6) Remove exhaust manifold.
7) Remove water outlet cap.
8) Loosen cylinder head bolts in such order as indicated in figure
1. Hex hole bolt
2. Timing chain side
3. Flywheel side
9) Remove cylinder heads.
tion 6.
Refer to Section 6F2 for CMP sensor removal and item "CAM-
SHAFT AND VALVE LASH ADJUSTER" in this section for cam-
shaft and valve lash adjuster removal.
Refer to item "EXHAUST MANIFOLD" in this section for remov-
al.
and remove them.
NOTE:
Don't forget to remove two hex bolts shown in figure.
ENGINE MECHANICAL (H25 ENGINE) 6A2-59