Suzuki 2000 Grand Vitara SQ625 Service Manual page 673

1. Bolts
2. Reduction gear assembly
11) Install packing so that cuts in packing align with holes for
12) Install plate and seal rubber to front housing.
1. Packing
2. Planetary gear
3. Bolt hole
4. Seal rubber
13) Apply grease to ball and install ball into shaft hole.
1. Ball
14) Install yoke, armature, brush holder and rear bracket to front
15) Tighten through bolts.
16) Install magnetic switch assembly and protector (if equipped).
17) Upon completion of assembly, carry out PERFORMANCE
1. Magnetic switch
2. Protector
through bolts in front housing.
housing by aligning match marks provided before removal.
Connect wire (switch to motor) to switch terminal.
TEST. (Refer to page 6G-16.)
CRANKING SYSTEM 6G-11