Suzuki 2000 Grand Vitara SQ625 Service Manual page 513

6B-8 ENGINE COOLING
3) Stop engine and open radiator drain plug to drain coolant.
4) Close drain plug (1). Add water until system is filled and run en-
5) Repeat steps 3) and 4) several times until drained liquid is
6) Drain cooling system and then close radiator drain plug tightly.
7) Disconnect hose from reservoir. Remove reservoir and pour
8) Add 50/50 mixture of good quality ethylene glycol antifreeze
1. Reservoir
2. FULL level mark
3. LOW level mark
4. Arrow mark
9) Run engine, with radiator cap removed, until radiator upper
10) With engine idling, add coolant to radiator until level reaches
gine until upper radiator hose is hot again.
nearly colorless.
out any fluid. Scrub and clean inside of reservoir with soap and
water. Flush it well with clean water and drain.
Reinstall reservoir and hose.
and water to radiator and tank.
Fill radiator to the base of radiator filler neck and reservoir to
"FULL" level mark. Reinstall reservoir cap, aligning the arrow
marks on the reservoir and cap.
hose is hot.
the bottom of filler neck. Install radiator cap, making sure that
the ear of cap lines up with reservoir hose.