Suzuki 2000 Grand Vitara SQ625 Service Manual page 335

1
1. Intake manifold
1. IAC valve
2. EGR valve
3. EVAP canister
purge valve
1. Heater hose
4. EVAP canister hose
2. Fuel feed hose
5. Vacuum hose
3. Fuel return hose
INSTALLATION
1) Install new intake manifold gaskets to cylinder heads.
1. Gasket
2) Install intake manifold.
3) Install throttle body to intake collector with new throttle body gas-
1. Intake collector
2. Throttle body
4) Install IAC valve, EGR valve, EVAP canister purge valve, man-
5) Install throttle body and intake collector assembly to intake man-
4. EVAP canister
purge valve hose
5. IAC valve hose
6. Clamp
6) Connect hoses of heater, EVAP canister, tank pressure control
Tighten bolts and nuts to specified torque.
Tightening Torque
.
(a): 23.0 N m (2.3 kg-m, 16.5 lb-ft)
ket.
Tighten bolts and nuts to specified torque.
Tightening Torque
.
(b): 23 N m (2.3 kg-m, 16.5 lb-ft)
ifold absolute pressure (MAP) sensor, clamps and each hoses
to intake collector and throttle body if removed.
Use new gasket, when installing IAC valve and EGR valve.
ifold with new intake collector gaskets.
solenoid valve, fuel feed and fuel return.
ENGINE MECHANICAL (H25 ENGINE) 6A2-11