Suzuki 2000 Grand Vitara SQ625 Service Manual page 272

6A1-30 ENGINE MECHANICAL (G16 ENGINE)
1. No. 1 bolts (short)
2. No. 2 bolts (long)
4) Install rotor plate. Tighten 5 screw securely.
After installing plate, check to be sure that gears turn smoothly
by hand.
5) Apply engine oil to guide seal and install guide seal and guide.
1. Oil pump
2. Oil level gauge
guide
3. Guide seal
INSTALLATION
1) Install two oil pump pins and oil pump gasket to cylinder block.
Use a new gasket.
2) To prevent oil seal lip from being damaged or upturned when
installing oil pump to crankshaft, fit special tool (Oil seal guide)
to crankshaft, and apply engine oil to special tool.
Special Tool
(A): 09926-18210
3) Install oil pump to cylinder block.
As there are 2 types of oil pump bolts, refer to figure for their cor-
rect use and tighten them to specified torque.
Tightening Torque
(a): 11 N
4) Install rubber seal between oil pump and water pump.
.
m (1.1 kg-m, 8.0 lb-ft)