Fader Function; Channel Level - Denon AVC-A1XVA Operating Instructions Manual

3
(Main unit)
When the surround back speaker setting is set to "1spkr" for "2-1. Speaker Configuration" (See pages 49, 50), this is set to "SB".

Fader function

• This function makes it possible to lower the volume of the front channels (FL, C and FR) or the rear channels (SL, SR, SBL and SBR) together.
Use it for example to adjust the balance of the sound from each position when multi-channel music sources are played.
1 Press the ENTER button then select "Fader".
• When pressing the ENTER button, the channel switches in the order
shown below each time the ENTER button is pressed.
FL
FADER
(Main unit) (Main unit)
(Remote control unit) (Remote control unit)
When the surround back speaker setting is set to "1spkr" for "2-1.
Speaker Configuration" (See pages 49, 50), this is set to "SB".
2 Press the cursor left button to reduce the volume of the front channels, the
cursor right button to reduce the volume of the rear channels.
The fader function does not affect the subwoofer channel.
(Main unit)
(Remote control unit)
The channel whose channel level is adjusted lowest can be faded to –12 dB
using the fader function.
If the channel levels are adjusted separately after adjusting the fader, the fader
adjustment values are cleared, so adjust the fader again.
138
Ajust the level of the selected speaker.
• The adjustment range for the different channels is +12 dB to –12 dB in step of 0.5 dB.
• The sound from the subwoofer can be completely cut by lowering the SW (subwoofer) setting
one additional from –12 dB (setting it to "OFF").
(Remote control unit)
C FR SW SRA
SLA SLB SBL
or
(Main unit)
or
(Remote control unit)
Example: When "FRONT" is selected
SRB
SBR
1
1,2
1
1, 2