Setting The Channel Level - Denon AVC-A1XVA Operating Instructions Manual

6
(Main unit)
(Remote control unit)
b. When "Manual" mode is selected:
q Select the speaker.
(Main unit)
7
(Main unit)
To cancel the settings, press the cursor left button to select "Level Clear" and "Yes" on the Channel
Level screen, then make the settings again.
NOTES:
• When adjusting the level of an active subwoofer system, you may also need to adjust the subwoofer's own volume control.
• When you adjust the channel levels while in the SYSTEM SETUP CHANNEL LEVEL mode, the channel level adjustments made will affect
all surround modes. Consider this mode a Master Channel Level adjustment mode.
• After you have completed the SYSTEM SETUP CHANNEL LEVEL adjustments, you can then activate the individual surround modes and
adjust channel levels that will be remembered for each of those modes. Then, whenever you activate a particular surround sound mode,
your preferred channel level adjustments for just that mode will be recalled. Check the instructions for adjusting channel levels within
each surround mode. (See pages 137, 138)
• You can adjust the channel levels for each of the following surround modes: PURE DIRECT/DIRECT, STEREO, DOLBY/DTS SURROUND,
HOME THX CINEMA, 9CH STEREO, WIDE SCREEN, SUPER STADIUM, ROCK ARENA, JAZZ CLUB, CLASSIC CONCERT, MONO
MOVIE, VIDEO GAME and MATRIX.
• When using either surround speakers A or B, or when using surround speakers A and B at the same time, be sure to adjust the balance
of playback levels between each channel for the various selections of "A or B" and "A and B".
54
a. When "Auto" mode is selected:
Test tones are automatically emitted from each speaker.
The test tones are emitted from each speaker in the following order,
at 4-second intervals the first time and second time around, 2-
second intervals the third time around and on:
FL C
SW SLA
When the surround back speaker setting is set to "1spkr" for "2-1.
Speaker Configuration", this is set to "SB".
Use the cursor left and right buttons to adjust all the speakers to the
same volume.
The volume can be adjusted between –12 dB and +12 dB in units of 0.5
dB.
w Adjust all the speakers to the same
(Remote control unit)
Enter the setting.
The Channel Level screen reappears.
(Remote control unit)
FR SRA SRB
2spkrs
SLB SBL SBR
SB
1spkr
volume.
(Main unit) (Remote control unit)
Flashing
Example: When the volume is set to –11.5 dB
while the test tone is being
produced from the Front Lch
speaker
T e s t T o n e A u t o
F L : - 1 1 . 5 d B
Flashing
Example: "Manual" mode is selected.
T e s t T o n e M a n u a l
F L : - 1 1 . 5 d B