Channel Level; Fader Function; Quick Select Function; Personal Memory Plus Function - Denon AVP-A1HD Owner's Manual

Channel Level

You can adjust the channel level either according to the playback
sources or to suit your taste, as described below.
1
CH SELECT
Press .
2
CH SELECT
Use ui or to select the speaker.
The speaker that can be set switches each time one of the
buttons is pressed.
3
Use o p to adjust the volume.
b "OFF" can be set by pressing o when the subwoofer's volume
is set to –12dB.

Fader Function

This function lets you adjust (fade) the sound from all the front or
rear speakers at once.
1
CH SELECT
Press .
2
CH SELECT
Press ui or to select "Fader".
3
Use o p to adjust the volume of the speakers.
o p
( : front, : rear)
• The fader function does not affect the subwoofer.
• The fader can be adjusted until the volume of the speaker adjusted
to the lowest value is –12 dB.

Quick Select Function

With this function, the currently playing input source, input mode,
surround mode, room EQ settings and volume can be stored in
the memory.
1
Set the input source, input mode, surround mode,
room EQ settings and volume to the conditions you
want to store.
2
QUICK SELECT
Press and hold the desired
Keep pressing the button until the quick select indicator lights.
[Quick Select Defaults]
Input Source
DVD
Quick Select 1
Quick Select 2 TV/CBL
Quick Select 3 VCR
QUICK SELECT
• To call out the settings, press
settings were stored.
• The Quick Select name can be changed (vpage 39).
NOTE
Input sources stored with the quick select function cannot be selected
if they have been deleted at GUI menu "Manual Setup" – "Option
Setup" – "Source Delete" (vpage 39). In this case, store them
again.

Personal Memory Plus Function

This function sets the settings (input mode, surround mode,
HDMI output mode, Picture Adjust, Audio Delay etc.) last selected
for the individual input sources.
When you switch to an input source, the settings are automatically
set to the ones that were set the last time that input source was
used.
The surround parameters, tone control, room EQ settings and the
volumes of the different speakers are stored for the individual surround
modes.

Last Function Memory

This stores the settings as they were directly before the standby
mode was set.
When the power is turned back on, the settings are restored to as
they were directly before the standby mode was set.

Backup Memory

.
The various settings are backed up for about 1 week, even if the
power is turned off or the power cord is disconnected.
Volume

Resetting the Microprocessor

–40 dB
–40 dB
Perform this procedure if the display is abnormal or if operations
–40 dB
cannot be performed.
All settings are reset when the microcomputer is reset.
1
Turn off the power using
at which the desired
2
<POWER>
Press
<STANDARD>
3
Once the display starts flashing at intervals of about 1
second, release the two buttons.
If in step 3 the display does not flash at intervals of about 1 second,
start over from step 1.
<POWER>
.
while simultaneously pressing
<HOME THX CINEMA>
and .