Setting The Delay Time - Denon AVC-A1XVA Operating Instructions Manual

NOTES:
— Assignment of low frequency signal range (2-1) —
• The only signals produced from the subwoofer channel are LFE signals (during playback of Dolby Digital or DTS signals) and the low
frequency signal range of channels set to "Small" in the setup menu. The low frequency signal range of channels set to "Large" are
produced from those channels.
— Subwoofer Setup (2-2) —
• The subwoofer mode setting is only valid when and "Yes" is set for the subwoofer in the "2-1. Speaker Configuration" settings (see
pages 49, 50).
• When the input signal is analog or a PCM signal not including LFE signals, if "LFE-THX-" is selected, the low frequency component is not
output from the subwoofer. To output the subwoofer channel, select "LFE+Main".

2-3. Setting the Delay Time

• Input the distance between the listening position and the different speakers to set the delay time for the surround mode.
• Two surround back speakers are required to use the THX Ultra2 Cinema, THX Music modes and THX Games mode.
Set the surround back speakers so that the distance to the listening position is the same for both the left and right speakers.
It is also recommended that the deviations of the distance from the listening position to L and R channel speakers (front left (FL) and front right
(FR), surround left (SL) and surround right (SR), surround back left (SBL) and surround back right (SBR)) is less than 60 cm (2 ft).
Preparations:
Measure the distances between the listening position and the speakers (L1 to L6 on the diagram at
the right).
L1: Distance between center speaker and listening position
L2: Distance between front speakers and listening position
L3: Distance between surround speakers and listening position
L4: Distance between surround back speakers and listening position
L5: Distance between subwoofer and listening position
L6: Distance between surround back L and surround back R
1
(Main unit) (Remote control unit)
2
(Main unit) (Remote control unit)
3
(Main unit) (Remote control unit)
Select "Delay Time" at the Speaker Setup menu.
* S p e a k e r S e t u p
D e l a y T i m e
Display the Delay Time screen.
* D e l a y T i m e
M e t e r s :
Select the desired unit, "Meters" or "Feet".
Subwoofer
F e e t
Example: When "Meters" is selected
FL Center FR
L
L
1
2
Listening position
L
5
L
4
L
SL SR
3
SBL SBR
L
6
51