Learning Function - Denon AVC-A1XVA Operating Instructions Manual

Learning function

If an AV component is not a DENON product, or if it cannot be operated via codes provided in the AVC-A1XVA remote control's internal preset
memory, or if its codes cannot be successfully learned by the AVC-A1XVA remote control, then you should use the remote control that was
supplied with that AV component to operate the component.
1 Press and hold the RC SETUP button for at
least three seconds.
• The IR segment blinks twice.
2 Press the "9, 7, 5" button (9
→ →
7 5) to select Learning
setup.
• The IR segment
twice, indicating the remote
is in Learning set up mode.
3 Press the mode selector button
for the component you want to
learned.
Learning is not possible for the
AMP, ZONE2, ZONE3 ZONE4
and SYSTEM CALL modes.
4 Press the button that you wish to be learned.
• The display will go off and the unit will enter the learning
standby mode.
If a button that cannot be "learned" is pressed, the IR
segment lights and the learning setup mode is cancelled.
The HOME button cannot be "learned".
5 Point the remote control units directly at each other and press
and hold in the button on the other remote control unit which
you want to "learn".
• The display turns on again and the IR segment blinks twice
to indicate that the code is successfully captured.
Other buttons can be "learned" by repeating steps 4 and
5.
The mode can be switched by pressing a mode selector
button.
If the IR segment displays one long flash, a leaning error
has occurred. Try repeating this step again until a
successful capture occurs.
122
blinks
Other remote
control unit
3
6 Press and hold the RC SETUP button for at
least three seconds to exit programming.
NOTES:
• To cancel the learning setup mode, press the RC SETUP button
for at least three seconds.
• Do not try to learn anything to the RC SETUP button.
IR segment
2
1, 6