Eop Switch Line Inspection; Eop Switch Removal/Installation - Honda NC700XA Service Manual

dummyhead dummyhead
LIGHTS/METERS/SWITCHES

EOP SWITCH LINE INSPECTION

Turn the ignition switch OFF.
Disconnect the EOP switch 1P (Gray) connector [1].
Check for continuity between the EOP switch connector
terminal and ground.
CONNECTION: Light green – Ground
– If there is continuity, the Light green wire has a short
circuit.
– If there is no continuity, replace the ECM/PCM with
a known good one, and recheck.
• If the ECM/PCM is replaced, perform the following:
– Key Registration Procedure (page 23-6)
– Clutch Initialize Learning Procedure (NC700XD/
SD) (page 12-120)
EOP SWITCH REMOVAL/
INSTALLATION
Remove the radiator reserve tank (page 8-14).
Disconnect the EOP switch 1P (Gray) connector [1].
Remove the EOP switch [2] from the crankcase.
Installation is in the reverse order of removal.
TORQUE: 18 N·m (1.8 kgf·m, 13 lbf·ft)
• Apply sealant to the EOP switch threads.
• Route the wires and hoses properly (page 1-25).
Check the engine oil level (page 3-12).
22-20
[1]
[2]
Lg
[1]