Transmission (Nc700Xd/Sd) - Honda NC700XA Service Manual

dummyhead dummyhead

TRANSMISSION (NC700XD/SD)

REMOVAL/DISASSEMBLY
MAINSHAFT/COUNTERSHAFT
Separate the crankcase halves (page 14-7).
Remove the countershaft assembly [1].
Remove the dowel pin [2] and countershaft bearing set
ring [3].
Disassemble the countershaft assembly.
Clean all disassembled parts in solvent thoroughly.
• Keep track of the disassembled parts (gears,
bushings, washers, and snap rings) by sliding them
onto a tool or a piece of wire.
• Do not expand the snap ring more than necessary
for removal. To remove a snap ring, expand the
snap ring and pull it off using the gear behind it.
Remove the mainshaft bearing set plate bolts [1] and
set plate [2].
Remove the right mainshaft bearing [1] from the upper
crankcase.
Remove the mainshaft assembly [1].
Disassemble the mainshaft assembly.
Clean all disassembled parts in solvent thoroughly.
• Keep track of the disassembled parts (gears,
bushings, washers, and snap rings) by sliding them
onto a tool or a piece of wire.
• Do not expand the snap ring more than necessary
for removal. To remove a snap ring, expand the
snap ring and pull it off using the gear behind it.
CRANKCASE/TRANSMISSION/BALANCER
[1]
[2]
[3]
[2]
[1]
[1]
[1]
14-17