Dual Clutch - Honda NC700XA Service Manual

dummyhead dummyhead
Connect the linear solenoid valve 4P (Green) connector
[1] and install it to the ABS modulator stay.
Install the following:
– Maintenance lid (page 21-6)
– Shroud/side cover (NC700XD) (page 2-14)
– Shelter/side cover (NC700SD) (page 2-15)
– Right engine side cover (page 2-30)
Fill the engine with the recommended engine oil and
check that there are no oil leaks (page 3-12).

DUAL CLUTCH

REMOVAL
Remove the right crankcase cover (page 12-97).
Align the gear teeth of the primary drive gear and sub-
gear [1] by prying the gears through the holes [2] and
hold them with a 6 mm socket bolt [3].
Remove the ball bearing [1].
Remove the dual clutch assembly [2] from the
mainshaft.
Remove the seal rings [1] from the mainshaft grooves.
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
[2]
[1]
[2]
[1]
[3]
[1]
12-105
[1]