Clutch - Honda NC700XA Service Manual

dummyhead dummyhead
Install the clutch lifter arm [1], return spring [2] and snap
ring [3].
• Align the return spring hook [4] with right crankcase
cover.
• Align the return spring end [5] with clutch lifter arm
groove.
• Make sure the snap ring is firmly seated in the
groove.
Apply engine oil to the clutch lifter rod A sliding surface.
Install the clutch lifter rod A [6].

CLUTCH

REMOVAL
Remove the right crankcase cover (page 11-5).
Remove the clutch lifter rod B [1].
Loosen the clutch lifter plate bolts [2] in a crisscross
pattern in 2 or 3 steps, and remove the bolts, lifter plate/
bearing [3] and clutch springs [4].
Unstake the clutch center lock nut [1].
Be careful not to damage the mainshaft threads.
Hold the clutch pressure plate with the special tool and
loosen the clutch center lock nut [1].
TOOL:
Clutch center holder [2]
Remove and discard the lock nut.
CLUTCH/GEARSHIFT LINKAGE (NC700X/XA/S/SA)
[4]
[3]
[2]
[1]
07JMB-MN50302
[2]
[1]
[6]
[5] [2]
[4]
[3]
Unstake
[1]
[1]
11-7