Injector - Honda NC700XA Service Manual

dummyhead dummyhead
FUEL SYSTEM
7. Check if the MIL blinks.
If the MIL begins short blink (0.3 seconds), the throttle valve fully closed position is reset.
MIL ON
MIL OFF
If the MIL stays lit, the throttle valve fully closed position is not reset, repeat the reset procedure from step 1.
8. Turn the ignition switch OFF.
9. Connect the ECT sensor 2P connector [1].

INJECTOR

REMOVAL
Relieve the fuel pressure and disconnect the quick
connect fitting from the injector side (page 7-4).
Remove the battery box (page 2-31).
Disconnect the injector 2P (Gray) connectors [1].
Remove the clip [2] from the fuel rail.
Remove the bolts [3], collars [4] and injector assembly
[5].
Remove the retainers [1] from the injector/fuel rail.
7-20
within 10 seconds
0.1
seconds
1.2
seconds
RESET RECEIVING PATTERN
0.3 seconds
0.3 seconds
SUCCESSFUL PATTERN
[3] [2] [4]
[4]
[1]
[3] [5]
[1]
[1]