Flywheel - Honda NC700XA Service Manual

dummyhead dummyhead
Installation is in the reverse order of removal.
• Apply liquid sealant (Three bond 1207B or
equivalent) to the alternator cover mating surface as
shown.
• Apply liquid sealant (Three bond 1207B or
equivalent) to the alternator wire grommet sealing
surface.
• Do not apply more liquid sealant than necessary.
• Replace the O-ring with a new one.
• Route the cables and wire harness properly (page 1-
25).
• Align the rear brake reservoir stay with the frame
tab.
Fill the engine with the recommended engine oil and
check that there are no oil leaks (page 3-12).

FLYWHEEL

REMOVAL
Remove the alternator cover (page 13-5).
Remove the starter idle gear shaft [1] and starter idle
gear [2].
Remove the starter reduction gear shaft [3] and starter
reduction gear [4].
Hold the flywheel [1] using the special tool and loosen
the flywheel mounting bolt [2].
TOOL:
Flywheel holder [3]
The flywheel mounting bolt has left hand threads.
Remove the flywheel mounting bolt and washer [4].
Remove the flywheel [1] using the special tool.
TOOL:
Rotor puller [2]
ALTERNATOR/STARTER CLUTCH
[4]
[3]
07725-0040001
[1]
[1]
07933-3290001
[2]
[3]
[2]/[4]
[1]
[2]
13-7