Ignition Switch - Honda NC700XA Service Manual

dummyhead dummyhead
LIGHTS/METERS/SWITCHES

IGNITION SWITCH

INSPECTION
Remove the shroud/side cover (NC700X/XA/XD) (page
2-14).
Remove the headlight/headlight stay (NC700S/SA/SD)
(page 2-27).
Disconnect the ignition switch 2P (Brown) connector [1].
Check for continuity between the wire terminals of the
ignition switch connector in each switch position.
Refer to the wiring diagram for the terminals and switch
status:
– NC700X (page 24-2)
– NC700XA (page 24-3)
– NC700XD (page 24-4)
– NC700S (page 24-5)
– NC700SA (page 24-6)
– NC700SD (page 24-7)
REMOVAL/INSTALLATION
Remove the top bridge (page 17-33).
Remove the ignition switch mounting bolts [1] and
ignition switch [2].
Installation is in the reverse order of removal.
TORQUE:
Ignition switch mounting bolt:
25 N·m (2.5 kgf·m, 18 lbf·ft)
Replace the ignition switch mounting bolts with new
ones.
22-24
NC700X/XA: NC700S/SA/SD:
[1]
NC700XD:
[2]
[1]
[1]
[1]