Right Crankcase Cover - Honda NC700XA Service Manual

dummyhead dummyhead

RIGHT CRANKCASE COVER

REMOVAL/INSTALLATION
Remove the following:
– Right shroud/side cover (NC700X/XA) (page 2-14)
– Maintenance lid (page 21-6)
Drain the engine oil (page 3-13).
Disconnect the CKP sensor 2P (Red) connector [1] and
release the CKP sensor harness.
Release the reserve tank overflow hose [1] from the
stay [2].
Remove the bolt [3] and stay.
Remove the bolts [1] and clutch cable guide [2], then
disconnect the clutch cable [3] from the clutch lifter arm
[4].
Loosen the right crankcase cover bolts [1] in a
crisscross pattern in 2 or 3 steps, and remove the bolts
and sealing washer [2].
Remove the right crankcase cover [3].
CLUTCH/GEARSHIFT LINKAGE (NC700X/XA/S/SA)
[2]
[4]
[3]
[1]
[1]
[3] [2]
[1]
[3]
[1]/[2]
[1]
11-5