Linear Solenoid Valve Body Disassembly - Honda NC700XA Service Manual

dummyhead dummyhead
DUAL CLUTCH TRANSMISSION (DCT) (NC700XD/SD)
Disconnect the clutch EOP sensor 3P connectors [1].
Remove the following:
– Bolt and shift spindle angle sensor [2]
– Bolt [3] and wire clip stay [4]
– Bolts [5] and wire clamps [6]
Remove the wire harness and shift spindle angle
sensor wire from the right crankcase cover.
Remove the bolts [1] and hose clamp [2].
Do not allow dust or
dirt to enter the oil
Remove the right crankcase cover [3].
passages.
Remove the oil joint pipe [1] and dowel pins [2].
Remove the O-rings from the joint pipe.
Remove the seal rings [3] from the mainshaft end.
LINEAR SOLENOID VALVE BODY
DISASSEMBLY
• Keep dust and dirt away from all the parts.
• Be careful not to damage the mating surfaces of the
valve body components.
Remove the right crankcase cover (page 12-97).
Remove the right crankcase cover wire clamp bolt [1]
and wire clamp [2].
Remove the wire grommets [3] from the right crankcase
cover.
12-98
[2] [3]/[4]
[1]
[3]
[3]
[1]
[5]/[6]
[1]
[2]
[3]
[2]
[1]
[2]