Alternator Charging Coil - Honda NC700XA Service Manual

dummyhead dummyhead
GROUND LINE INSPECTION
Turn the ignition switch OFF.
Disconnect the regulator/rectifier 2P (Black) connector
[1] (page 21-8).
Check for continuity between the regulator/rectifier 2P
(Black) connector at the wire side and ground.
CONNECTION: Green – Ground
There should be continuity at all times.

ALTERNATOR CHARGING COIL

CHARGING COIL INSPECTION
Disconnect the alternator 3P (Black) connector [1]
It is not necessary
(page 21-8).
to remove the stator
coil to make this
Measure the resistance between the alternator 3P
test.
(Black) connector each terminals at the wire side.
CONNECTION: Yellow – Yellow
STANDARD:
Check for continuity between the alternator 3P (Black)
connector [1] each terminals at the wire side and
ground.
CONNECTION: Yellow – Ground
STANDARD:
Replace the stator if the resistance is out of
specification, or if any wire has continuity to ground.
For alternator/starter replacement (page 13-13).
0.1 – 0.5 Ω (20°C/68°F)
No continuity
BATTERY/CHARGING SYSTEM
[1]
Y
Y
[1]
Y
Y
[1]
G
Y
Y
21-9