Fuel Level Sensor - Honda NC700XA Service Manual

dummyhead dummyhead

FUEL LEVEL SENSOR

FUEL LEVEL SENSOR INSPECTION
Remove the fuel pump unit (page 7-11).
Connect the ohmmeter to the fuel pump unit 3P (Black)
connector [1] terminals.
CONNECTION: Red/black – Black/white
Inspect the resistance of the float [2] at the top and
bottom positions.
Resistance
FUEL METER INSPECTION
If the fuel meter blinks as shown [1] with ignition switch
is ON, perform the inspection as follow:
Disconnect
connector (page 22-8).
Disconnect the fuel pump unit 3P (Black) connector
(page 7-10).
Check for continuity between the combination meter
16P (Gray) connector [2] and fuel pump unit 3P (Black)
connector [3] of the wire harness side.
CONNECTION: Black/green – Black/green
If there is no continuity, check for open circuit in Black/
green wire and loose contact of the wire harness
connectors.
FULL
4 – 6 Ω 80 – 83 Ω
the combination meter
LIGHTS/METERS/SWITCHES
EMPTY
[1]
[1]
16P (Gray)
[2]
[1]
Bl/W R/Bl
Bl/G
Bl/G
22-21
[2]
[3]