Suspension; Front Suspension Inspection - Honda NC700XA Service Manual

dummyhead dummyhead
MAINTENANCE
Remove the sidestand springs [1].
Remove the sidestand pivot nut [2], bolt [3] and
sidestand [4].
Apply grease to the sidestand pivot bolt sliding surface.
Install the sidestand and sidestand pivot bolt.
Tighten the sidestand pivot bolt to the specified torque.
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf·ft)
Loosen the sidestand pivot bolt 45 – 90°.
Install and tighten the sidestand pivot nut to the
specified torque while holding the pivot bolt.
TORQUE: 39 N·m (4.0 kgf·m, 29 lbf·ft)
Install the sidestand springs.
Install the sidestand switch [1].
• Align the sidestand switch groove with the frame pin.
• Align the sidestand switch tab with the sidestand
hole.
Install and tighten a new sidestand switch bolt [2] to the
specified torque.
TORQUE: 10 N·m (1.0 kgf·m, 7 lbf·ft)

SUSPENSION

FRONT SUSPENSION INSPECTION

Check the action of the forks by operating the front
brake and compressing the front suspension several
times.
Check the entire assembly for signs of leaks, damage
or loose fasteners.
Replace damaged components which cannot be
repaired.
Loose, worn or damaged suspension parts impair
motorcycle stability and control.
Tighten all nuts and bolts.
For fork service (page 17-25).
3-28
[2]
[4]
Align
Align [1]
[3]
[1]
[2]