Grab Rail; Center Seat Cowl - Honda NC700XA Service Manual

dummyhead dummyhead
FRAME/BODY PANELS/EXHAUST SYSTEM

GRAB RAIL

REMOVAL/INSTALLATION
Open the pillion seat using the ignition key.
Remove the clip [1], washer [2], spring [3] and pillion seat hinge [4] from the pillion seat stay.
Right grab rail:
Remove the caps [5] from the mounting socket bolts [6].
Remove the mounting socket bolts, washers [7] and grab rails [8] while holding the collars [9].
Be careful not to let the collars fall into the seat cowl.
Remove the collars from the grab rail.
If necessary, remove the clips [10], washers [11] and pillion seat hinge from the right grab rail.
Installation is in the reverse order of removal.
[11]

CENTER SEAT COWL

REMOVAL/INSTALLATION
Open the pillion seat using the ignition key.
Remove the socket bolts [1].
Pull up the center seat cowl rear end and release the
center seat cowl tabs [2] from the seat cowl slits [3] by
pulling the center seat cowl [4] rearward.
Installation is in the reverse order of removal.
2-8
[10] [4] [1]
[2]
[3]
[9]
[1]
[5]
[6]
[7]
[8]
[2] [4]
[3]