Check To Make Before Installation; Combination Table Of Accessories - Canon iR C3380 series Service Manual

Chapter 2
DADF-L1 + Finisher-Z1 + Side Paper Deck-Z1
DADF-L1 + Saddle Finisher-Y2 + Puncher Unit-L1 + Buffer Pass Unit-E1 + Side Paper deck-Z1
7) The machine must be placed in a well ventilated area. It is important to make sure, however, that the machine is not near the air vent (for suction) of the room.

2.1.2 Check to Make Before Installation

/ / iR C3380 / iR C2880
Be sure to go through the following before starting the work:
1) If you are installing the machine after moving it from a cold to warm location, be sure to leave the machine unpacked for at least 2 hours so that the machine is
fully used to the site temperature, thus avoiding image faults caused by condensation.
(The term "condensation" refers to the formation of droplets of water on the surface of a metal object brought in from a cold to warm place, i.e., as the result of
the rapid cooling of the moisture (vapor) around the object.)
2) The machine weighs a maximum of about 125 kg (including a DADF). Be sure to work in a group of 4 persons when lifting it.
Also, lift the main body while keeping it level.

2.1.3 Combination Table of Accessories

/ / / / iR C3380i / iR C3380 / iR C2880i / iR C2880
The following table shows the combination of accessories that are set at the right side of the host machine.
When setting the accessories indicated in the table, refer to the table below and check the combination before the setup.
Document Tray-J1
Voice Guidance Kit-B1
Voice Operation Kit-A1
Card Reader-C1
yes: Available no: Unavailable
2-2
4" (100 mm) or more
63" (1,601 mm)
55" (1,398 mm)
F-2-3
84 3/4" (2,153 mm)
4 1/4" (107 mm)
89" (2,261 mm)
F-2-4
T-2-1
Document Tray-J1 Voice Guidance Kit-B1
-
no
no
yes
4" (100 mm) or more
Voice Operation Kit-A1
no no
- no
no -
yes yes
0013-8398
0014-5103
Card Reader-C1
yes
yes
yes
-